INSTALLATION OF YOUR TUFFER BUFFER


1) REMOVE BARREL BAND (IF APPLICABLE)





2) YOUR SAFETY WILL LOOK LIKE THIS
 
  PUSH IT IN HALF WAY UNTIL IT LOOKS
           LIKE THE PICTURE BELOW







3) LOOSEN THE TAKE DOWN SCREW (FOUND ON THE
BOTTOM OF THE STOCK), LIFT UP AND REMOVE
AND RECEIVER BARREL




4) MOVE THE TRIGGER ASSEMBLY FROM THE RECEIVER BY KNOCKING OUT THE CROSS PINS SHOWN





5) KNOCK OUT THE FACTORY BOLT STOP PIN. THE FACTORY PIN IS SOMETIMES HARD TO KNOCK OUT AND MAY REQUIRE SOME HEAT (HAIR DRYER) TO REMOVE IT.

 





6) INSERT TUFFER BUFFER ROD IN STOP PIN HOLE AND PUSH
THROUGH TO OTHER SIDE. MAKE SURE BUFFER ROD ENDS
ARE FLUSH WITH RECEIVER HOLES.
** NOTE: BUFFER ROD MAY BE "TACKY" WHEN INSTALLING.
ADDING A LITTLE WATER, LIGHT GUN OIL, ETC, WILL HELP IT
SLIDE EASIER. WIPE DRY WHEN DONE.





7) WHEN THE BUFFER IS IN, COCK YOUR HAMMER BACK, SLIDE YOUR TRIGGER ASSEMBLY INTO THE RECEIVER AND PUT YOUR CROSS PINS BACK IN PLACE.








 




8) PUT YOUR RECEIVER AND BARREL BACK INTO YOUR
STOCK & TIGHTEN YOUR TAKE DOWN SCREW AND BAND.





CONGRATULATIONS!!!
YOU JUST INSTALLED YOUR TUFFER BUFFER!!
joomla site stats